All

Anti-rust Tripod Bracket Air Conditioner Hold

Inquiry

Overview
Inquiry
Related Products

Advantage of Anti-rust Tripod Bracket Air Conditioner Hold

Strong & Durable- Hot rolled plate construction with powder-coating surface treatment. Anti-rusting, anti-corrosion and weather resistant, Perfect for long-term outdoor use and fits most of mini split ductless air conditioner heat pump systems.

Universal design- Fits most of mini split ductless air conditioner heat pump systems,Support up to 250KG,Suitable for 9000-36000 BTU capacity units.

Easy to install- Simple structure,easy to install, all necessary hardware included.And provide vibration isolation pads to control noise and vibration.

Ensure adequate airflow- Slight rearward tilt to wall is recommended for safety purposes.The bracket will leave you with a gap of approximately 6 inches to ensure sufficient airflow for condensing operations.

Condensers protection- Install the bracket on the wall and elevate the compressor unit above the ground to prevent dust, snow, debris etc. Keep the condenser clean and prolong its service life.

No	Size	A(mm)	B(mm)	C(mm)	D(mm)	Weight (KG/SET)	Maximum load (KG)	Accessories
1	SXD250	250	163	98	210	5.7	120-280	With 2 sets of screws
2	SXD400	400	163	98	360	8.7	160-430	With 4 sets of screws
3	SXD450	450	163	98	410	9.82	200-480	With 4 sets of screws
4	SXD500	500	163	98	460	10.98	280-580	With 4 sets of screws
5	SXD600	600	163	98	560	13.1	300-680	With 4 sets of screws
6	SXD1000	1000	163	98	960	21.46	380-1180	With 4 sets of screws
7	SXX450	450	130	60	410	5	160-420	With 4 sets of screws
8	SXX500	500	130	60	460	6.3	160-420	With 4 sets of screws

Anti-rust Tripod Bracket Air Conditioner Hold manufacture

Anti-rust Tripod Bracket Air Conditioner Hold factory

How to use a flaring tool to expand a tube (operation ):

1. Used for copper tube expanding to bell mouth, so that the indoor and outdoor units of the split type air conditioner will be connected through piping. 2. When flaring, attach the coupling nut to the annealed copper pipe first; 3. Then place the copper tube into the corresponding aperture of the gripping pliers, the height of the copper tube showed out of the clamp is1/5 of the diameter; 4. Tighten the nut on both ends of the gripping pliers (clamp); 5. Use the the taper head of the flaring tool to press on the pipe nozzle ; 6. Slowly rotate the screw clockwise and squeeze the pipe nozzle into the bell-mouth.